Back to top.
Remove window sash vinyl.
The bottom of the window will pull out when the sash is lifted.
Free the window from the frame by removing the snap molding from around the fixed window.
The sash has to be low and level before you lift the first side out of the jamb liner.
If it is catching you may need to pop it out with a putty knife or utility knife.
Plus you ll want to learn how to remove your window s sash so that you can clean them without going outside.
The little metal cam on the bottom corner of your sash will brake the locking terminal that s under tension inside the track.
Remove the old sash and weights.
Sash installation removal instructions pdf 108kb.
Duck tape 5 00 screwdriver 3 00 camera or smartphone free window sash free depending on warranty.
To remove the lower sash begin by opening it.
Or if the window doesn t tilt connelly suggested using a putty knife to gently pry back the vinyl enough to free the sash.
But be cautious because you don t want to ruin the vinyl.
Remove extraneous items such as screens storm windows and shutters.
How to remove a double hung window sash.
Close up of photo 1.
Measure at three places on both the side and top choosing the smallest of the three measurements for the side and the top.
How to remove a sash in a non tilt vinyl or aluminum window.
Remove both sash from the window frame using pliers to disconnect the spring loaded strings from each side of the sash.
Yank out the staple holding each spring balancer in place.
Some windows may have a window opening control device that does not allow the window to be opened more than a few inches.
Remove the window sash from the vinyl track.
Because you could get a new sash or entire window for free.
Here are the supplies you ll need for this super quick project.
Lifting is usually all that is needed to remove a sliding window from the frame.
Lift up on handle as pictured or turn the spoon depending on the window series you have.
How to measure for a new window sash.
How to remove a sash in a non tilt vinyl or aluminum window.
Remove the old balancers from the window header.
Measure the height and width of the window opening with a tape measure.