Revit View Range Roof Plan

Elements falling in the primary view range will use the projection line weight.

Revit view range roof plan.

The view range settings are linked to three horizontal planes that control the visibility and display of objects in a plan view top cut plane and bottom as well as an additional plane called view depth. The view range button must be clicked to access the view range. And one of the most critical and confusing aspects of any floor plan is view range. Draw the sketch as necessary then click finish.

The bottom setting of the view range is not used in a reflected ceiling plan. Alternatively enter vr on the keyboard. First the floor plan or ceiling plan must be opened using the project browser. View depth is established in the up direction from the cut plane.

Now when you click the boundary you created above you will see view range in properties palette. You can do this by using plan region. In this example i only need to create a rectangular boundary. You will need to define the plan region using sketch tool.

However exceptions to this are floors ramps stairs and any component that is hosted by a floor. View range settings apply to plan views and reflected ceiling plans model elements outside are the view range are not normally shown. Open a plan view. It s the only property you can change for this object.

You can find this tool in view tab create panel plan views drop down plan region. Users can access the view range with just a few clicks. The area between the cut plane and the top of the view range establishes the primary view range of the view. The view range dialog looks complicated but most of the time what you need to set is simple.

On the properties palette locate the view range parameter and click edit. In plan view adjust cut plane and bottom values. Video describing the revit view range settings for plan views. Floor plans are an essential part of any revit project.

Click it and change it as necessary. Once the floor plan or ceiling plan is open the view range button becomes available in the properties panel see figure 1.