Revit Roof Ridge Line

If the eves are at the same height the overhang is the same and the slope is the same the ridge line will appear in the middle of the roof.

Revit roof ridge line.

To create a dormer model required walls and additional roof. Then follow these 2 steps. Start with a flat roof then highlight the roof then in the options bar you will see various buttons on lets you place points on the roof the one that looks like a line lets you draw a ridge line. The footprint is fine and i want the slopes to be based off of the ridge location and wall height not manually entered as i dont know what they will end up being.

After creating a roof you can change its shape or overhang cut openings or align ridges. It is a matter of geometry. Use it to extend the dormer roof to the main roof. The tiles are nested into a line based generic family and arrayed with constraints to the beginning and end.

9 join roofs add opening to create dormer. How to create roof ridge caps and roofing sheets in revit models in a simple way. The tile spacing is variable i modeled a revit roof for each roof pitch that we normally encounter then used sections and detail views to determine the appropriate angle for each hip and ridge type. Example 2 roof by footprint with different slopes on of 30 degrees and one of 50 degrees.

Note that you can place the ridge exactly where you want it. For this we have to change the height of the right eave using offset from roof base at a negative value. Micrographics https www mgfx co. Edit the roof sketch double click the roof or select the roof and click modify roofs tabmode panel edit footprint or edit profile.

When you are sketching the roof revit assumes all lines of the sketch are at the same height. This tool is located in the modify tab. Use join unjoin roof tool. How to create roof ridge caps and roofing sheets in revit models in a simple way.

I want the ridge to align with the column that is slightly to the left. We want to move the ridge by 1 50 meters to left. Now the formula becomes. I ve attached a image of the elevation you can see the gap in the beams where i want to move the roof ridge.

If you want to change the position of the roof use the properties palette to edit the base level and offset properties to change the position.