Replacing Old Hardwood Floor Boards

Cut one board in half lengthwise.

Replacing old hardwood floor boards.

Using the chisel and a pry bar remove the strip of flooring between the relief cuts and pull the tongue and groove edges of the old flooring where they interlock with the adjacent flooring courses. Refinishing old hardwood floors. Chisel out the edges of the old floorboard after prying out the center section being careful to avoid the nails on the groove edge. You can also fix buckled areas of flooring and avoid having to completely refinish your floors.

Next buy replacement flooring and let it acclimate in the room for 3 days so it doesn t shrink or expand after you install it. Just make sure the cuts are perfectly square. To replace hardwood floor start by cutting and prying up the old hardwood planks using a circular saw pry bar and mallet. Hardwood floors take a lot of abuse and over time they can become stained warped chipped or just dull.

Then remove any nails and staples in the subflooring and sand off any paint or adhesive. It doesn t matter what kind of saw you use to repair your hardwood floors. Completely clean out the opened section of flooring. Cut a new length of flooring to fit snugly into the space of the old board.

Most likely this will be an oil based varnish or oil based polyurethane. Hardwood falls in the middle on the comfort scale. Remove the bottom of the groove from the new floor plank. The wood in vintage floors can be harder than in contemporary ones because there is more chance it was obtained from old growth trees and that the boards are quartersawn.

When your hardwood floor begins to appear worn out you can refinish it to restore its. Most floors use a tongue and groove design for connecting adjacent strips. If your hardwood flooring is still in good condition you may decide that it s worth keeping and putting to use elsewhere. Tile will last forever under normal conditions but carpet and laminate may need replacement in ten years or less.