Removing Wrinkles From Vinyl Pool Liner

Flatten out any residual wrinkle.

Removing wrinkles from vinyl pool liner.

Liners can develop wrinkles as they become hardened. If your pool is not full of water and there are a few wrinkles in the lining you want to get rid of you can smooth out the wrinkles with a toilet plunger. You can remedy this by heating the pool to at least 92 degrees. Wrinkles on the wall of a vinyl liner pool are usually a result of a liner that has shifted while water was under it but has now settled since the water has receded.

This pushes air between the liner and pool wall pushing wrinkles out of the liner. For large pool wrinkles you ll definitely need to remove water from the pool. Drain the pool until there is between one and four inches of water on the liner. How to remove wrinkles from inground vinyl liner pool.

Step 4 drain the pool. Lastly liner wrinkles can also be caused by water leakage. Use shop vacuum to push air under the liner if none of the above works you can drain your pool and use a shop vacuum in reverse placing the hose between the liner and pool wall then start vacuum. If you have just removed the cover to your pool and have not filled the pool with water yet and you have found that the liner is floating now is a good time to prevent wrinkles from forming as you are adding water to the pool you will be able to move the liner around to position it as it should be as it begins to sit back against the.

This pushes air between the liner and pool wall pushing wrinkles out of the liner. This means that the liner may have a leak that allows the water to occupy the space underneath thus creating the wrinkles. If this is the case it can be very hard to move the wrinkles as they will be inclined to return to their original spot. You are advised not to put the toilet plunger directly on the wrinkle but you can put it to the side of it to remove wrinkles from the pool liner.

Use shop vacuum to push air under the liner if none of the above works you can drain your pool and use a shop vacuum in reverse placing the hose between the liner and pool wall then start the vacuum. Pull the liner to the sides of the pool which pulls the floor of the liner tight.