Removing Carpet Spikes

You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish.

Removing carpet spikes.

Begin at the top of the stairs. Roll up the strips and tape them for easy handling. Pry up the metal nosing and remove it if present. Carpet is installed using glue or tack strips.

Carpet can stain and wear out over time so plan to replace it every five to ten years especially if it is installed in high traffic areas like living rooms. How to lift a carpet up without damaging it. Fold the carpet over for easy cutting and slice it into narrow strips. In order to remove carpet easily and efficiently it s best to cut the carpet into 4 foot wide strips.

Just grab the carpet with pliers and pull. You need to loosen about a foot of carpeting to attach to the machine. In most cases glue down carpet cannot be lifted up without damaging the backing or tearing the carpet. A very easy way to remove carpet tack strip from the basement concrete floor.

Use measuring tape to determine proper width image 1 then use a carpet blade to cut the carpet into 4 foot wide strips image 2. Its not that hard with these tips from clay king from aaa flood drying with 28. If you are pulling up carpet from stairs. If you re aggressive enough one or two solid blows with the hammer against the heel of the pry bar should be sufficient to dislodge the nails.

Then grab the carpet by hand and continue to pull it up along an entire wall. Removing these strips that once held your carpet is the most tedious part of carpet removal. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Remove the baseboards and pull up a corner of the carpet using a claw puller or pliers.

After pulling up your carpet you will most likely have tack strips left around the perimeter of the room.