But if there are significant puddles or multiple low areas use one or more portable sump pumps to remove that standing water.
Remove standing water from crawl space.
How to prevent flooding and remove water in a crawl space.
If your wet crawl space is a minor issue meaning there s not much water present use a wet dry vacuum to remove the water.
Even if it is operating properly back it up with another pump to move out standing water as quickly as possible.
Place the pump in the impromptu moat and use the pump there.
Stop the flow of water if water is still entering the crawl space stop the flow immediately and repair any leaks.
If you have a sump pump in the crawl space make sure it s working.
It can be difficult to insulate cold water pipes under your house.
While a professional is probably the better option in the case of large amounts of standing water you ll want to remove any vapor barrier which has been placed and dig a three to four inch trench around the outside of the crawlspace.
Extract the water utilize a pump to remove the standing water from the crawl space.
Then insulate cold water pipes to prevent condensation.
Don t allow your crawl space to air dry after this step.
You just have to insulate them.
Look for signs of standing puddling water on the ground and signs of the discoloration caused by mildew and wood rot on the wooden posts piers and overhead structural members of the house.
Remove the vapor barrier if your crawl space already has a plastic vapor barrier it should be removed rolled up and removed through the access door.
Finish with a wet vacuum.
A hose draws the water into the vacuum compartment to be discarded outside.
Invest in a wet dry vacuum.
The insulation will ensure that any condensation occurring will not impact the air around it.
If the crawl space floor were flat and drained to one single low point just one sump pump would usually be enough.
Make sure the hoses are correctly attached to the pump so the water is pushed away from the house.
How to remove standing water and dry a crawl space.
Use a wet dry vaccum to remove standing water.