Remove Carpet Staples Quickly

Remove this small piece of carpet and then pull up on the larger section.

Remove carpet staples quickly.

Instead they ve developed a smart efficient way to remove staples with a shovel or long handled floor scraper. If it won t come up then cut a small 6 inch by 6 inch square in the corner with your utility knife. Those tacks are beyond sharp. Hold the tool at about a 45 degree angle and slide it forcefully along the floor.

To easily remove the carpet tack strip move the pry bar near a nail and pry up while gently lifting the end of the tack strip with your other hand. Tough spots might require a power oscillating tool. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Roll up the strips and tape them for easy handling.

Fold the carpet over for easy cutting and slice it into narrow strips. This video will show you the fastest way to remove staples from your floor when taking out carpet. With this method you ll never break a strip unless the wood is rotten. You ll be able to use the pliers to quickly pull out the rest of the staple and can then move on with the rest of the job.

On a concrete floor the carpet pad is often glued into place. Oh and do be careful when removing carpet tack strips. Just grab the carpet with pliers and pull. Here were our weapons of choice basically all serving the purpose of prying things up carpet tack strips staples at varying levels of detail and care crowbar for yanking up carpet pliers for delicately twisting stuck staples out.

Http amzn to 2tv9o2n the handyguys demonstrate use diagonal pliers to remove carpet staples embedded in a wood f. It also shows how to remove carpet pad staples easy https. In this case use a floor scraper to remove the pieces of padding that remain stuck to the floor. If any of the carpet staples have loosened up on one side but won t come all the way out then you ll need to grab the pliers.

With a motion similar to using a push broom go around the entire room to slice off or yank out the staples with the scraper. It can be aggravating but necessary to take the time to go around and remove them quickly to make your new install as clean and secure as possible. Once the crowbar helped me loosen a corner or two of the carpet it was fairly easy to just yank it up by hand. A few tools are helpful at getting this done as quickly as possible.

Choose a staple remover. Start at one corner of your room and try to pull up the carpet. After removing carpeting it s a common sight to find many leftover staples stuck in the subfloor. Your carpet is held down with tack strips.