Take it from a 31 year professional installer put down the baseboards first leaving a gap at the bottom for the very best.
Remove baseboards to replace carpet.
Wedge your taping knife between the board and the wall to create space.
The carpet is attached to the tack strip stretched and cut along the tack strip.
Baseboards do not need to be removed.
Flex the knife in the grove a bit to create some spacing.
Therefore you do not have to raise the baseboard if it was installed with normal space underneath for carpet installation typically a piece of scrap plywood or subfloor or baseboard is used as a gage during installation so you see 3 8 and 1 2 space commonly although i have seen as much as 1 which is too much for most carpets.
The tack strip is nailed around the perimeter of the room right along side the base board.
Find more great content from di.
Once it is secured to the strip a carpet tucker is used to secure the remainder of the carpet underneath the baseboard.
I am also thinking about replacing with some nicer baseboards.
I am going to be having new carpet installed in 4 bedrooms.
Then the cuts are tucked between the tack strip and baseboard for a finished look with a putty knife.
Your average carpet installer is capable of replacing the baseboards but there is always the risk of damage when trying to remove it.
In addition the tack strip will be under the baseboards.
There are a few benefits to removing the baseboards before installing wall to wall carpeting.
Over time or with a lot of foot traffic carpets can pull away from the walls or fray around the edges.
Dan and tim faires show how to remove old baseboards without damaging the walls and replace them for an updated modern look.
Position your taping knife at the top edge of the newly made score.
How to replace baseboard trim in a carpeted room.
There is little difference between the steps to install baseboard in a room that is already carpeted and one where the carpet has yet to be laid.
If so how high should i place the new baseboard.
Should i remove the baseboards before installation.
Grab your hammer and tap the knife in deeper to give yourself more of a hold.